① Container bag manufacturer: punching material. First, the plastic woven bag hanging ring screw conjugation system should be affixed to the castin floor of the packaging production line, so that the bottom foundation of the plastic woven bag and the asphalt road touch, and then the plastic woven bag punching open, set up the material cylinder and clamp by the clamping special equipment to prevent smoke dust or suspended matter exposed. The raw materials of the boot packaging line are put into the bag from the punching hole, and the bag body is straightened before the can is filled.
② Loading and unloading. The screw of the lifting ring of the ton bag should be attached to the hydraulic elevator in a balanced manner. According to the type of ton bag and the amount of cargo loaded, electric forklift trucks, lifting equipment and truck cranes can be used. Once the electric forklift is used to lift the ton bag, the shovel plate should be adjusted to the correct specific position, the ton bag should be close to the electric forklift, do not tilt forward. In order to ensure that the point of the bag body is stable and balanced during lifting, be careful not to remove the single ring. Then, the boot hydraulic hoist will gradually raise the ton bag, and after reaching a high degree, it is evenly distributed and placed on the ordinary train (or car) table. Once it is not necessary to load and unload immediately, the working environment should be consistent, and do not lightly press each other, tilt, impact, etc., during the whole process of lifting and placing.
Container bags (3) Storage. Under normal circumstances, after loading the car materials in tons of bags, it should be loaded and left immediately, but if it cannot be shipped back immediately due to specific circumstances, in order to prevent damage to raw materials, tons of bags should be stored in the warehouse, and water, steam, wet and cold sources and continuous high temperature sources should be eliminated near the indoor environment. When storing outside the coffins, in addition to meeting the necessary conditions of the indoor environment described above, waterproof canvas should be paid attention to Cover and prevent the sun from shining for long periods of time.
④ Discharging. Lift the ton bag with electric forklift or car crane, point to the mouth of the chute or other glass container, open the bottom edge of the bag and tie the rope, the raw and auxiliary materials can automatically slide down and discharge. For disposable tons of bags, the bottom of the bag can be punctured remotely with a suitable special tool. Do not stand behind a ton bag during unloading
CONTACT
